Rki-instruments SDM-2009 PC Controlled Configuration Manual de usuario descargar pdf (Pagina 20)

15 • Hardware Setup

GAS Tubing

Reference Figure 13 for the instructions below.

1. Cut a 3-4” piece of 3/16 inch tubing for each GAS fitting on every SDM-2009

except the last one.

2. Connect the tubing to the GAS fitting on every SDM-2009 except the last one.

3. Insert the smaller T-fittings into the tubing so that the remaining two ports on

the T-fitting are perpendicular to the GAS fitting.

4. Cut 6-7” pieces of 3/16 inch tubing and connect the T-fittings.

5. Cut one more 6-7” piece of 3/16 inch tubing and connect the GAS fitting of the

last SDM-2009 to the T-fitting from the second to last SDM-2009.

6. Cut 1 piece of 3/16 inch tubing long enough for easy access to the calibration

cylinder and connect it to the T-fitting on the first SDM-2009.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 113 114

Sin comentarios

Rki-instruments SDM-2009 PC Controlled Configuration Manual de usuario Pagina 20