Rki-instruments M2 Rig Monitor Manual de usuario descargar pdf (Pagina 36)

31 M2 Rig Monitor Operator’s Manual

Adjusting Strobe/Horn Volume

The horn volume on the strobe/horn can be adjusted by doing the following:

1. Disconnect the battery clamps from the + and - terminals of the 12 VDC battery.

2. Loosen the captive screw at the bottom front of the strobe/horn.

3. Grasp the top and bottom of the strobe/horn and push up and out in order to remove

the cover.

Figure 10: Top Case Removal

4. Turn the cover over and locate the Audio Select switch at the top of the cover as

shown in the figure below.

Figure 11: Strobe/Horn Cover

5. The Audio Select switch can be set at any number between 1 and 6. Numbers 1-3 all

produce an intermittent buzzing sound with 1 being the loudest and 3 being the

quietest. Numbers 4-6 all produce a steady buzzing sound with 4 being the loudest

and 6 being the quietest. The factory setting is 2.

Push Up Here

Captive

Screw

Push Out

Top

Base

Audio Select Switch

AUDIO

SELECT

Strobe Brightness Switch

(DO NOT ADJUST)

CANDELLA SELECT

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 52 53

Sin comentarios

Rki-instruments M2 Rig Monitor Manual de usuario Pagina 36