Rki-instruments SDM-2012 PC Controlled Configuration Manual de usuario descargar pdf (Pagina 50)

45 • Connecting Instruments to the PC Controller Program

4. Turn on each SDM-2012 by pressing and holding the SDM-2012’s POWER

button. When the control panel LEDs turn on, release the POWER button.

5. The BUMP T and CAL S LEDs will turn off and the COPY LED will be

steadily on or off. It will be on if the SDM-2012 was used in Standalone

Configuration and calibration and bump test records are still stored in the

SDM-2012’s memory (see the SDM-2012 Docking Station Standalone

Configuration Manual for more information). The CHARGE LED will be

blinking green if the SDM-2012 is operating properly or solid red if there is a

system failure.

6. When a connection has been established between the SDM-GX Docking

Station PC Controller Program and all of the SDM-2012s, the main program

window will appear as shown below.

Figure 32: SDM-2012 Connection

7. Connect the gas out to instrument line of each SDM-2012 to the inlet of each

instrument.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 217 218

Sin comentarios

Rki-instruments SDM-2012 PC Controlled Configuration Manual de usuario Pagina 50